Accepta 6007 is a high performance, highly concentrated solid chemical multi-functional cooling water treatment scientifically formulated using the very latest anti-scaling, anti-fouling and corrosion inhibition technologies.
Accepta 6007 is a highly effective cooling water treatment product developed for the inhibition of ferrous metal corrosion using both cathodic and anodic protection; it also incorporates copper corrosion inhibitors; and molybdate.
Accepta 6007 contains PBTC phosphonate, HEDP phosphonate, Versaflex One, Ter-polymer, HPA, POCA, triazole and molybdate.
Accepta 6007 available in fully recyclable plastic bottles each containing 5kg of concentrated solid chemical.
Accepta 6007 is packaged in cases containing 4 x 5kg bottles.
Each case weighs 20kg.
- Innovative solid chemical technology
- High performance multi-functional scale and corrosion inhibitor with an anti-foulant
- Provides system protection at low product dosage rates
- Ferrous metal and copper corrosion inhibitors
- Significant safety improvements
- Easy to handle, simple to dose
- Environmentally friendly
- Reduces carbon footprint
- Significant space savings
|Appearance:||Tan to brown amorphous solid|
|Odour:||Slight characteristic odour|
|Softening point:||49 - 55 oC|
|Bulk density:||1098 kg/m3|
|Solubility in water:||Complete but dissolves slowly|
|pH (1% solution):||8.0 – 9.0|
*Full details of the product properties are available in the Safety Data Sheet. See below.
Application & Dosage Information
The initial recommended application rate for Accepta 6007 is 50 ppm. The application rates provided below are based on the corrosive indices of particular waters, however in practice, rates should be set to suit individual water conditions.
|Water Quality Range*||Dosage||Test Range|
|Ryzner Stability Index||Chemical level in
|6.0 - 6.5||10 - 25ppm||2 - 4ppm||0.5 - 1.0ppm|
|6.5 - 7.5||25 - 40ppm||4 - 6.5ppm||1.0 - 1.6ppm|
|7.5 - 8.5||40- 50ppm||6.5 - 8ppm||1.6 - 2.0pp|
(* <50 Ca, <100 ppm alkalinity)
* At a dosage rate of 20 ppm, 1 case of Accepta 6007 is equivalent to approximately 227kg of a conventional liquid product. Comparative values will vary, dependent upon concentration.
Testing and Control
Molybdate (as Mo) test kits suitable for monitoring and controlling the use of Accepta 6007 are available from Accepta. Accepta test kits for organo-phosphonate can also be used.
Feed Accepta 6007 using an an Accepta board system.
It is always advisable to carry out a 'Control Of Substances Hazardous to Health' (COSHH) assessment before use.
For further technical assistance concerning Accepta 6007 please contact Accepta.
Safety, Storage & Handling
For full details concerning safety precautions, storage and handling procedures for Accepta 6007 please refer to the latest Safety Data Sheet. To download the latest safety data for this product use the following link: