Accepta 2628 is a high performance industrial cleaner and scale remover developed for the cleaning of metals without concern of excessive corrosion.
Accepta 2628 is scientifically formulated using an inhibited blend of citric acid and wetting agents that will readily remove iron and copper oxides in heat exchangers and boilers.
Being an organic acid, Accepta 2628 is a mild cleaner and can be used on most metals without concern of excessive corrosion.
- High performance industrial cleaner and scale remover
- Based on inhibited blend of citric acid and wetting agents
- Readily removes iron and copper oxides in heat exchangers and boilers
- Suitable for most metals without concern of excessive corrosion
- Convenient liquid product
|Colour:||Clear, pale yellow|
|pH:||3.5 - 4.0|
|Specific Gravity:||1.15 - 1.25|
*Full details of the product properties are available in the Safety Data Sheet. See below.
Application & Dosage Information
The dosage of Accepta 2628 will vary depending on the amount and type of deposit in the system.
It is normally recommended that Accepta 2628 be dosed to give a 20 - 25% solution (as product).
Testing of the acid strength is recommended to ensure that there is enough residual acid present to remove the deposits.
Specific recommendations can be provided by us.
Accepta 2628 should be diluted with water to give a solution of the desired strength.
The solution temperature should be kept below 60°C to obtain the best protection from the inhibitors.
The cleaning solutions should be circulated and provisions must be made for venting of gases generated during the cleaning.
Depending on the type of deposit, carbon dioxide and some hydrogen gas may be formed.
Open flames should not be allowed in the vicinity of the cleaning due to the potential for hydrogen gas formation.
Once the cleaning is complete the system should be immediately drained, flushed and neutralized with an alkaline product supplied by us.
After recirculating the neutralizing solution, the system should be drained and flushed one final time.
It is always advisable to carry out a 'Control Of Substances Hazardous to Health' (COSHH) assessment before use.
For additional assistance please contact Accepta.
- pH Extech Stick pH meter
- Minilab pH meter + buffers
Material of Compatibility
Safety, Storage & Handling
Accepta 2628 is a mildly acidic solution. Avoid contact with skin, eyes or clothing. If skin comes into contact with product, wash with water. If eyes are affected, flush with water for at least 15 minutes and get medical attention.
For full details concerning safety precautions, storage and handling procedures for Accepta 2628 please refer to the latest Safety Data Sheet. To download the latest safety data for this product use the following link: