Accepta 2618 is a high performance supplemental corrosion inhibitor scientifically formulated for the treatment and protection of yellow metals in cooling water systems.
Accepta 2618 has been developed as a concentrated organic water treatment product specific to the protection of yellow metals and is designed to supplement a primary corrosion inhibition programme within open re-circulating cooling water systems and also closed loops.
- High performance corrosion inhibitor for open re-circulating cooling water systems and closed loops
- Ideal for the protection of yellow metals
- Cost effective, concentrated organic product
- Designed to supplement primary corrosion inhibition programmes
- Convenient liquid product
|Colour:||Clear, pale amber|
|pH:||11.5 - 12.5|
|Specific Gravity:||1.00 - 1.10|
|Freezing Point:||0°C (32°F)|
*Full details of the product properties are available in the Safety Data Sheet. See below.
Application & Dosage Information
The target dosage range for Accepta 2618 is 20 – 200 ppm as product in the re-circulating cooling water.
Accepta 2618 should be fed neat or as part of an appropriate mix to the cooling water system where it can be uniformly mixed and thoroughly distributed using a chemical metering pump.
Appropriate use of Accepta 2618 following the above dosing strategy should result in a corrosion rate of less than 0.5 mpy on yellow metals.
It is always advisable to carry out a 'Control Of Substances Hazardous to Health' (COSHH) assessment before use.
For additional assistance please contact Accepta.
- Not applicable
Material of Compatibility
Safety, Storage & Handling
Accepta 2618 is an alkaline solution. Avoid contact with skin, eyes or clothing. If skin comes into contact with this product, wash with water. If eyes are affected, flush with water for at least 15 minutes and get medical attention.
For full details concerning safety precautions, storage and handling procedures for Accepta 2618 please refer to the latest Safety Data Sheet. To download the latest safety data for this product use the following link: