Accepta 2551 is a high performance, very low foaming non-ionic bio-dispersant scientifically formulated for the removal of microbiological build-up, debris, slimes and biofilm in cooling towers and cooling water systems.
Accepta 2551 has the benefit of being extremely low foaming and is especially effective for the treatment of cooling water systems when used in conjunction with a microbiocide.
Accepta 2551 is stable over a wide pH range.
Accepta 2551 is not a biocide.
- High performance cooling water bio-dispersant
- Removes microbiological build-up, slimes and biofilm
- Extremely low foaming
- Helps maintain cooling system heat transfer efficiency
- Improves the effectiveness of any biocide programme
- Compatible with most biocides
- Can be used during cooling tower chlorination procedures
- Stable over a wide pH range
|Composition:||Aqueous solution of non-ionic surfactants|
|pH:||6 - 8|
|Specific gravity:||1.001 (at 20 0C)|
*Full details of the product properties are available in the Safety Data Sheet. See below.
Application & Dosage Information
Typical dosage rates for Accepta 2551 when dosed continuously are 1 - 2.5ppm.
The dosage rate of Accepta 2551 will depend on the level of system contamination.
When “shock dosing” a badly contaminated system apply a heavy bleed-off.
Always remember that biofilm may contain Legionella bacteria. Accordingly, you should always use Accepta 2551 in conjunction with a suitable biocide.
Closed systems must be flushed thoroughly with fresh water.
Accepta 2551 is compatible with most cooling water treatment products.
It is always advisable to carry out a 'Control Of Substances Hazardous to Health' (COSHH) assessment before use.
For further technical assistance concerning Accepta 2551 please contact Accepta.
Safety, Storage & Handling
For full details concerning safety precautions, storage and handling procedures for Accepta 2551 please refer to the latest Safety Data Sheet. To download the latest safety data for this product use the following link: