Accepta 2541 is a high performance water treatment corrosion inhibitor based on a molybdate / borate blend, scientifically formulated for the protection of brass, copper and steel in water systems.
Accepta 2541 contains no phosphate or nitrite additives and so does not encourage unwanted microbiological growth in the system.
All components of Accepta 2541 are halogen stable.
IMPORTANT - Accepta 2541 is NOT suitable for systems containing aluminium.
- High performance corrosion inhibitor for brass, copper and steel
- Minimises unwanted microbiological system growth
- Halogen stable
|Composition:||Aqueous solution of borate and molybdate salts|
|Specific gravity:||1.136 @20 oC|
|Boiling point:||> 100°C|
*Full details of the product properties are available in the Safety Data Sheet. See below.
Application & Dosage Information
Dose Accepta 2541 at 0.55% of the system volume and maintain a molybdate level of at least 180 ppm and a pH greater than 9.
Microbiological control can be achieved by the use of both oxidising and non-oxidising biocides.
Do not mix Accepta 2541 with other chemicals unless advised by Accepta.
It is always advisable to carry out a 'Control Of Substances Hazardous to Health' (COSHH) assessment before use.
Measure molybdate levels using an Accepta drop test or comparator based method.
For further technical assistance concerning Accepta 2541 please contact Accepta.
Safety, Storage & Handling
For full details concerning safety precautions, storage and handling procedures for Accepta 2541 please refer to the latest Safety Data Sheet. To download the latest safety data for this product use the following link: